Backorder | Back Order

Power 60 Brushless Outrunner Motor, 400Kv, 3.5mm Bullet

Item No.
E-flite - EFLM4060A
$126.99
RC Club points earned on this item shown at checkout.
Product $126.99
Add Ons
Estimated Total: $126.99
Estimated Total: $126.99
Selected Store

Overview

The Power 60 is designed to deliver clean and quiet power for 60-size sport and scale airplanes weighing 6 to 10 pounds (2.7–4.5 kg), 46-size 3D airplanes up to 7 pounds (3.2 kg), or models requiring up to 1200 watts of power. It’s an especially good match for Hangar 9 .60-size warbirds like the Corsair 60 (HAN2575), P-47D Thunderbolt 60 (HAN2975), P-40 Warhawk 60 (HAN2850), P-51 Mustang 60 (HAN2375), P-51 Miss America 60 (HAN2775) and .46-size 3D planes such as the Hangar 9 Funtana 40 (HAN1975) or Seagull Harrier 46 (SEA3025).

Needed To Complete

  • 80A brushless ESC
  • 5S–7S Li-Po or 16- to 24-cell Ni-MH/Ni-Cd
  • 14x8 to 16x10 prop
Examples of Airplane Setups:
NOTE: All data measured at full throttle. Actual performance may vary depending on battery and flight conditions.
Hangar 9 P-51 Miss America (HAN2775)
Motor: Power 60
ESC: Castle Creations Phoenix 80 (Standard settings with 18V Soft Li-Po cutoff and no brake)
APC 15x10E
Battery: Thunder Power PRO LITE 6000mAh 6S3P (THP60003S3PPL x2 in series)
Flying Weight w/Battery: 8.8 lb
AmpsVoltsWattsInput Watts/PoundRPM
56.021.311951367375
Expect very strong performance with a great balance of thrust and top speed. Average duration is approximately 8 to 15 minutes depending on throttle management.
Seagull Harrier 3D 46 (SEA3025)
Motor: Power 60
ESC: Castle Creations Phoenix 80 (Standard settings with 18V Soft Li-Po cutoff and no brake)
Prop: APC 16x8E
Battery: Thunder Power PRO LITE 4200mAh 6S2P (THP42003S2PPL x2 in series)
Flying Weight w/Battery: 6.4 lb
AmpsVoltsWattsInput Watts/PoundRPM
50.521.010601656975
Expect very strong performance with unlimited vertical and plentiful power for hovering and 3D aerobatics. Average duration is approximately 8 to 15 minutes depending on throttle management.

Key Features

  • Equivalent to a 60-size glow engine for 6 to 10 lb (2.7 to 4.5 kg) airplanes
  • Ideal for 46-size 3D airplanes up to 7 lb (3.2 kg)
  • Ideal for models requiring up to 1200 watts of power
  • High-torque, direct-drive alternative to inrunner brushless motors
  • Includes mount, prop adapters and mounting hardware
  • External rotor design—6mm shaft can easily be reversed for alternative motor installations
  • Slotted 14-pole outrunner design
  • High-quality construction with ball bearings and hardened steel shaft
  • NOTE: Not recommended to use with E-flite 80-Amp Pro Switch-Mode ESC (EFLA1080B)
  • Quiet, lightweight operation

Product Specs

Motor Type
Brushless
Recommended Prop Range
14x8 to 16x10
Shaft Diameter
6mm (.24 in)
Wire Gauge
14 AWG
Outer Diameter
2 in (50mm)
Adjustable Timing
No
Voltage
18.5 to 28.8
Connector Type
3.5mm Bullet
Idle Current (Io)
2.70A @ 10V
RPM/Volt (Kv)
400
Motor Design
Outrunner
Bushing Or Bearing
Bearing

Compatibility

No results for your given fitment filters

FAQ

The airplane is setup for 6S LiPo (either one 6S, or two 3S connected in series). Suitable propellers for the Power 60 motor are 16x8E or 15x10E