share' Share Review by Bob47 on 10 May 2014 facebookfacebook Share Review by Bob47 on 10 May 2014twittertwitter Share Review by Bob47 on 10 May 2014LinkedInlinkedin Share Review by Bob47 on 10 May 2014
Was this review helpful?
Lt H.3.0 star rating
Main Bearing Clearence
Review by Lt H. on 14 Dec 2012review stating Main Bearing Clearence
I believe the clearence between the middle main bearing and the top of the one way bearing should be slightly more then the interference fit it comes from the factory with. One or Two thousanths of an inch will do it, otherwise you will notice goves being cut into the one way bearing outer casing caused by contact with the middle main bearing. To achieve this you need to sand down the thichness of the shim that comes with this set. The main gear will need to be adjusted on the one way bearing to maintain the clearance between it and the tail rotor gear. The pinion gear will need to be adjusted properly also. I haven't found any documentation on this, to date.
share' Share Review by Lt H. on 14 Dec 2012 facebookfacebook Share Review by Lt H. on 14 Dec 2012twittertwitter Share Review by Lt H. on 14 Dec 2012LinkedInlinkedin Share Review by Lt H. on 14 Dec 2012