Perfect for the TinyWhoop! Great little frame that takes a decent amount of abuse. The downside is that if the frame gets cracked at all, you need to throw it away and replace it. CA doesn't bond to the frame's plastic so it's not easily repairable. Other than that, great frame!

Broke the original frame in a hard landing/crash easy to install fit perfectly.

This is an exact replacement so there's no concern about fit or appearance although care must be taken when extracting and reinserting the motors.

The flight controller is held in place with 4 screws that require a #0 Phillips screwdriver and I would recommend a pair #00 tweezers to remove and reinstall the motor connectors.

My only complaint is the frame's fragility. While a good design overall it would be a 'great one' if they would manufacture the frame using a far less brittle plastic (at the very least reinforce those all too fragile motor mount struts that break on even light impact.)

Regarding repair, to my knowledge the only glue that is compatible with the plastic used is solvent-based SCIGRIP 16. The bond isn't nearly as strong as the original joint but it is considerably stronger than epoxy designed for plastics, CA, or traditional model cement.

The struts holding the motors in place break extremely easily.
Also out of stock. Probably because it is so fragile?

Notice that one of the supports that holds the motor, frame, was broke. Don't remember even landing hard. Ridiculously fragile.