Overview
This controller has been designed for use in radio control aircraft and to support continuous currents of up to 10 amps when using 2–3 cell Li-Po battery packs and up to 4 sub-micro servos. Standard features include advance BEC and safe power-arming along with programmable features such as low-voltage cutoff, braking, timing and throttle input range.
Key Features
- Up to 10-amp continuous current with proper air flow
- Programmable motor braking
- Safe power-arm mode prevents accidental starts
- Programmable low-voltage cutoff with settings for 2-cell Li-Po (6V), 3-cell Li-Po (9V) or 70% of battery starting voltage
- Programmable throttle input range (1.1ms–1.9ms or Auto Select)
- Auto motor shutdown if signal is lost or there is interference
- Programmable timing—2 user-selectable ranges for use with a large variety of brushless motors
- Pre-wired connectors—JST on battery input and 2mm female gold bullets on motor output leads
- Soft start
Product Specs
Amperage
Brakes
Connector Type
Maximum Burst Current
Output Connector
Part Type
Programmable
Get Info From Communities
FAQ
The included manual has programming instructions, and you would want to enter 'programming menu 1' to change LiPo cutoff to 2S. It should take less than a minute and only needs to be done once (unless you change your batteries to 3S). Here's a link to the manual if you need it:
https://www.horizonhobby.com/on/demandware.static/-/Sites-horizon-master/default/dw1f616e75/Manuals/EFLA1010_manual.pdf