This item is no longer available
Image for LUX V2 Flight Controller (MPU6000) from HorizonHobby
+ / - Hover over image to Zoom
LUX V2 Flight Controller (MPU6000)
  • Overview
  • Specs
  • Reviews
  • Manuals & Support

Overview

The Lumenier LUX V2 flight controller is the next generation of the popular Lumenier LUX. It uses a powerful F3 processor along with top of the line hardware. Unleash the capabilities of your FPV Racing Quadcopter with the Lumenier LUX Flight Controller. Achieve gyro refresh rates up to 8kHz (high speed SPI) using popular Betaflight, CleanFlight and RaceFlight firmware along with ultra low looptimes. The LUX comes with BetaFlight pre-installed.*

The LUX V2 builds on all the best features of the V1 board and further improves on hardware components and layout. Now you get a whopping 5x dedicated UART ports for periphials, along with an SD Card slot for practically unlimited data logging. The MPU has also been updated to the low noise MPU6000 Gyro making tuning even easier. No longer do you need to solder jumper pads for PPM/SBUS selection, it is automatically chosen via software! The powerful F3 MCU also supports the latest DSHOT protocol available in the newest BetaFlight firmware.

The Lumenier LUX is a very low profile board allowing it to be mounted in a variety of ways. Signal wires can be soldered directly to the pads to save on size and weight. The LUX supports PPM or Serial RX (including Futaba, FrSky, S.BUS, DSMX). A signal inverter is already included for S.BUS.

Please note: PWM input for individual channels is not supported.

*The LUX V2 has its own target in Betaflight, be sure not to update it with the old LUX V1 firmware.

V2 Updates

  • Dedicated UART for RC RX use, no need to solder a jumper to select PPM/SRX anymore.
  • Dedicated telemetry UART, this brings the total to 5x plus USB.
  • SD Card slot for BlackBox data recording (SD card not included)
  • Low noise MPU6000 SPI Gyro.
  • USB detection can disable things like buzzer when configuring on the bench.
  • New ultra low noise regulators for MCU and IMU power systems.
Dimensions (WxLxH): 36x36x6mm (includes USB in height)
Weight: 5g

FAQs

Product Support Tips

Product Support