Intuitive and easy to use button and LEDs for frequency selection
Provides 5v power output for FPV cameras
Small sized and light weight
Transmitter frequency: 5658-5925MHz with 600mW power output
Transmitting distance > 2000m (open area)
SMA Antenna connector
Dimensions: 32 x 22 x 9mm (not including SMA adapter)
Audio: Includes on board microphone
The Lumenier TX5G6R Mini 600mW 5.8GHz 32CH FPV video transmitter is the perfect VTX for long range FPV, and FPV racing where you need the extra power! The high output 600mW transmission power means longer range and better signal penetration compared with lower power transmitters. The TX5G6R has 32 channels including the new Raceband frequencies. Our friends from ImmersionRC first divided the 5.8 band into 8 channels evenly spread out 37MHz from each other, which allows more racers flying at the same time on the same band. Lumenier Raceband transmitters are fully compatible with FatShark and ImmersionRC receivers. The Tx includes a 5v output to power FPV cameras and an on-board microphone to transmit audio to your receiver.
The TX5G6R features an easy to use single button, LED interface. It also comes with a clean pre-wired harness, and only weighs 7.5g! This transmitter outputs a lot of power, so mount it in an area where will have good air flow.
Note: TX antenna must be installed properly before it is switched on. Powering on without installing an antenna, or using an improper antenna may easily burn the TX, and such damage is not covered by warranty. When using this transmitter on builds with ESC's that feature regenerative braking, we strongly recommend powering the transmitter with the included 12V step down regulator to protect it from voltage spikes.
Operating Voltage: 7 - 20V
Supply current: 260 mA
Operating Temperature: -10 +85 C
Video Band Width: 5-6 MHz
Audio carrier Frequency: 6.5 MHz
Video Input Level: 0.8,1.0,1.2 Vp-p
Video Input Impedance: 75 Ohm
Audio Input Level: 0.8 ,2.0 Vp-p
Audio Input Impedance: 10K Ohm
Weight: 7.5g (without antenna)
Antenna Connector: SMA Female Connector
Video Format: NTSC/PAL
Frequency Selection: Single push to change CH, push and hold for 2 seconds to change FR
What's in the box?
(1) Transmitting unit (VTX) TX5G6R
(1) Antennas (2db)
(1) Power/Video cable
Locking connector, female JST for voltage in, female servo plug for video and 5v out