60-Amp Pro Switch-Mode BEC Brushless ESC V2: EC3
Tire and Tech Specials!

60-Amp Pro Switch-Mode BEC Brushless ESC V2: EC3

Item No.
E-flite - EFLA1060B
3.2
$49.99
Was $97.99. Save $48! Ends 4/30. ⓘ
RC Club points earned on this item shown at checkout.
Product $49.99
Add Ons
Estimated Total: $49.99
Estimated Total: $49.99
The link to 60-Amp Pro Switch-Mode BEC Brushless ESC V2: EC3 has been copied
Selected Store

Overview

The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

If you are purchasing this ESC to replace the ESC in your Carbon-Z Cub SS (EFL12450/EFL12475) or the Carbon-Z Cessna 150 (ELF1450/EFL1475) you will need the DYNC0029 adapter

Key Features

  • Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds)
  • 5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required)
  • Stronger BEC for support of most 3-axis stabilization systems
  • Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
  • 3- to 6-cell Li-Po, 9 to 18-cell Ni-MH/Ni-Cd input voltage
  • Finned heat sinks
  • Programmable motor braking
  • Safe power-arm mode prevents accidental starts
  • Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
  • Programmable throttle input range (1.1ms-1.9ms or 1.2ms-1.8ms)
  • Programmable soft start for helis and airplanes
  • Auto motor shut down if signal is lost or there is interference
  • Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors
  • Utilizes new smaller MOSFET technology to minimize weight
  • Radio system power on/off switch
  • Pre-wired connectors—E-flite® EC3â„¢ connector on battery input and 3.5mm gold bullet connectors on motor output leads

Product Specs

Input Voltage
10.8V - 22.2V
Part Type
Electronics
Maximum Burst Current
15 sec @ 75A
Wire Gauge
13 AWG
Connector Type
EC3
Brakes
Yes - Programmable
Programmable
Yes
Output Connector
3.5mm Bullet
Amperage
40-60
Replacement Parts
Optional Parts

Get Info From Communities

RC 101
Buying Guides
Troubleshooting
Downloads
How-To's

FAQ

For starters, make sure the motor is connected since it generates the tones produced by the ESC. If your low voltage cutoff is set to percentage mode, a song will sound to let you know, instead of the specific cell-number beeps that you hear when the ESC's LVC is set to a specific cell count. Percentage mode simply takes whatever battery voltage you give it and cuts the motor when the voltage declines to 74% of the original value.