Blade CX3 MD 520N RTF Electric Micro Helicopter

Team Tips

• Tail Twitching in hover or forward flight
  

  Possible fix:

  Adjust Gyro gain slightly or add double sided tape on the front landing gear tabs to help isolate the body from motor vibration. This should solve this issue. 

• Tail Drifting after 1-2 minutes of flight
  

  Possible fix:

  Land the Heli then center the rudder trim and re-initialize the 3-in-1 unit.  Drifting is caused by the change in battery voltage during flight operation.

• Remote LED light set will not function
  

  Possible fix:

  Make sure it is properly connected into channel 5 of the AR6100 receiver.  When using the LP5DSM transmitter turning the 5th channel knob clockwise or counter-clockwise will switch the lights on and off.  On other transmitters be sure to set the travel adjustment to +/- 100%

• The CX3 3-in-1 unit LED continues to flash the RED LED
  

  Possible fix:

  Check to make sure that the transmitter throttle stick and throttle trim lever are completely DOWN, then re-initialize the 3-in-1 unit.

• The transmitter is on and the flight battery is connected but still no control
  

  Possible fix:

  Cycle the transmitter power and re-initialize the 3-in-1 unit.  Move the transmitter about 3 feet from the helicopter and make sure the antenna is not pointing directly at the Heli. 

  If the problem persists, re-bind the receiver to the transmitter.